© 2026 Sinochem Nanjing Corporation,
All Right Reserved
Product Name: 2,2-Bis-4,4-Di-Tert-Butylperoxy-Cyclohexyl Propane
Synonyms: Peroxide compound, organic peroxide
Product Code: Industry-specific code assigned by manufacturer
Intended Use: Cross-linking agent, vulcanizing agent, chemical intermediate
Manufacturer: Name, full address, and emergency phone number required on the shipping label
Contact Information: 24-hour helpline with clear instructions for emergencies
Recommended Restrictions: Not for food, medical, or pharmaceutical use; only to be handled by trained staff
Classification: Organic peroxide Type E (UN classification), oxidizer, irritant
GHS Label Elements: Flame pictogram, exclamation mark, oxidizer pictogram
Signal Word: Danger
Hazard Statements: May cause fire or explosion; strong oxidizer; may cause skin and eye irritation; harmful if swallowed, inhaled, or in contact with skin
Precautionary Statements: Avoid heat, sparks, open flame, contact with combustible materials; avoid breathing dust or fumes; do not eat, drink, or smoke when handling; wear protective gloves, eye protection, and clothing
Other Hazards: May cause delayed symptoms in case of contact; dust can form explosive mixtures with air; combustible materials exposed to product may ignite with delay
Chemical Name: 2,2-Bis-4,4-Di-Tert-Butylperoxy-Cyclohexyl Propane
CAS Number: 3006-82-4
Concentration: Organic peroxide ≤42%, inert solid content ≥58%
Impurities/Additives: May contain traces of stabilizers; relevant only if present above regulatory thresholds
SDS Components: Hazardous substances identified according to current chemical regulations
General Advice: Move person to fresh air; remove contaminated clothing immediately; keep warm and at rest
Inhalation: Move affected individual outside; support breathing if necessary; get medical attention if symptoms persist
Skin Contact: Rinse contact area with plenty of water for several minutes; wash with soap; seek medical advice for irritation, blistering, or burning
Eye Contact: Remove contact lenses; flush eyes gently but thoroughly with water for at least 15 minutes; always consult a medical professional after eye contact
Ingestion: Do not induce vomiting; rinse mouth; give water only if person is fully conscious; immediate medical attention is essential
Most Important Symptoms: Redness, itching, inflammation, coughing, respiratory distress in severe cases
Notes for Doctors: Symptomatic treatment; monitor for pulmonary or systemic complications from oxidizing agent exposure
Suitable Extinguishing Media: Dry chemical, carbon dioxide, foam; use water spray to cool containers not involved in fire
Unsuitable Extinguishing Media: Never use water jets directly on burning substance; avoid high-pressure water as it may spread the material
Specific Hazards: Vigorous decomposition releases oxygen and heat; strong oxidizer; increases combustion risk for nearby materials
Products of Combustion: Carbon monoxide, carbon dioxide, other unidentified organic compounds
Protective Equipment: Full turnout gear, self-contained breathing apparatus; prevent skin and respiratory exposure
Fire-Fighting Instructions: Withdraw to a safe distance in case of large fire; cool closed containers with water mist; avoid exposure to decomposition vapors
Personal Precautions: Wear recommended personal protective equipment; evacuate unnecessary personnel; ensure adequate ventilation to disperse vapors and dust
Environmental Precautions: Prevent entry into drains, surface water, and soil; inform authorities in cases of large spillage
Methods for Cleanup: Remove all ignition sources; collect spills with non-combustible absorbents (vermiculite, sand, diatomaceous earth); place in tightly closed, labeled containers for disposal; clean residues with water while avoiding splashing
Handling Spilled Material: Prevent powdered material from becoming airborne; isolate area until cleanup is completed; disposal of recovered material must comply with local regulations
Handling: Work in well-ventilated areas; avoid skin or eye contact and inhalation of dust/fumes; ground handling equipment; keep away from reactive or combustible substances; use anti-static tools
Storage Conditions: Store in original, tightly closed containers; segregate from foodstuff, reducing agents, acids, bases, flammable, and organic materials; keep in cool, dry, well-ventilated places; recommended storage temperature ranges from 2°C to 8°C or per manufacturer's instructions
Incompatibilities: Avoid storage near free radicals, metal salts, heavy metals, strong acids, alkalis, combustibles
Storage Class: Organic peroxide storage according to local fire code; keep away from direct sunlight and sources of ignition
Exposure Limits: No established occupational exposure limits for this specific compound; local ventilation advisable
Engineering Controls: Install fume hoods, local exhaust ventilation, explosion-proof electrical systems
Respiratory Protection: Use NIOSH-approved respirators when risk of airborne exposure exists; dust masks for small quantities
Hand Protection: Wear impermeable, chemical-resistant gloves (nitrile, neoprene, butyl rubber recommended)
Eye/Face Protection: Tight-fitting chemical splash goggles; use face shield if risk of splashing
Skin and Body Protection: Chemical protective clothing; avoid synthetic fabrics that can build static charge
Hygiene Measures: Wash exposed areas with soap and water after handling; never eat, drink, or smoke near chemicals
Appearance: White or off-white powder or granules, may have slight odor
Odor: Slight, may be faintly aromatic
Odor Threshold: Not established
pH: Not available
Melting Point/Freezing Point: Decomposes before melting; approximate decomposition at 70°C to 90°C
Boiling Point/Range: Not applicable (decomposes before boiling)
Flash Point: Not established, but supports combustion
Evaporation Rate: Not applicable (solid material)
Flammability (solid/gas): Supports combustion; may explode and propagate flame in contact with combustibles
Upper/Lower Flammability Limits: Not available
Vapor Pressure: Not significant at room temperature
Vapor Density: Not applicable
Relative Density: Typically 1.1–1.3 g/cm³ (may vary)
Solubility: Insoluble in water; soluble in certain organic solvents
Partition Coefficient (n-octanol/water): Not available
Auto-Ignition Temperature: Not established; may be sensitive to heat
Decomposition Temperature: 70°C or higher
Viscosity: Not applicable
Chemical Stability: Normally stable at recommended storage conditions; readily decomposes on heating
Conditions to Avoid: Heat, sunlight, friction, shock, sources of ignition, contamination by impurities
Incompatible Materials: Reducing agents, acids, alkalis, heavy metals, metal salts, flammable substances, combustible materials
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, various organic compounds
Possibility of Hazardous Reactions: Violent decomposition or detonation on rapid heating, friction or impact, especially if confined
Acute Toxicity: Oral and dermal LD50 data unavailable, expected to be moderately toxic; inhalation may result in respiratory irritation
Skin Corrosion/Irritation: Causes redness, irritation, possible burns on prolonged contact
Serious Eye Damage/Irritation: Causes severe irritation, watering, possible injury
Respiratory or Skin Sensitization: May cause allergic reaction after repeated exposure
Chronic Effects: No detailed studies available, avoid repeated or prolonged contact
Carcinogenicity: Not classified as a human carcinogen
Mutagenicity and Reproductive Toxicity: No evidence available
Other Health Effects: Exacerbates existing respiratory disorders, dermatitis
Aquatic Toxicity: May pose hazard to aquatic life due to oxidizing properties; avoid release to environment
Persistence and Degradability: Organic component will degrade over time; breakdown products persist until further degraded
Bioaccumulative Potential: Potential for accumulation in living organisms low, given rapid breakdown
Mobility in Soil: May bind with soil particles; unlikely to leach but contaminates soil if spilled
Other Adverse Effects: Toxic if released in large quantities to waterways, can deplete oxygen
Disposal Methods: Dispose in accordance with local, regional, and national legislation for hazardous chemical waste
Waste Treatment: Solid should not enter municipal waste; thermally destroy through licensed chemical incineration in facilities accommodating peroxides
Contaminated Packaging: Handle like unused product until thoroughly cleaned; consider as hazardous waste
Special Precautions: Segregate from other waste types; never landfill peroxides
UN Number: 3106 (Organic peroxide type E, solid)
UN Proper Shipping Name: Organic peroxide type E, solid
Transport Hazard Class: 5.2 (organic peroxides)
Packing Group: II
Labels: Oxidizer, organic peroxide
Environmental Hazards: Marine pollutant label may apply based on local conventions
Special Transport Precautions: Keep away from heat during transport; comply strictly with transport regulations
Other Transport Information: Emergency schedules for spillage, response, and disposal must accompany shipment; drivers and handlers must receive safety information
TSCA Status: Listed or otherwise regulated under TSCA
OSHA: Hazardous by definition of Hazard Communication Standard
EPCRA Section 302: Not extremely hazardous but reportable based on quantity
SARA Title III: Not subject to section 313 reporting
Other Regulations: Subject to transport regulations for hazardous materials within jurisdictions such as DOT, IMDG, IATA
Inventory Status: May be listed with EINECS, DSL, AICS, and other national inventories
Labeling Requirements: Fulfills all hazard communication requirements for workplace chemicals; GHS-compliant labels and safety instructions required
